Knowledgebase: Patton Articles
How do I run a system debug on a Patton Gateway?
Posted by , Last modified by on 20 January 2011 12:25 PM
Using an SSH client, SSH or Telnet into the Patton's IP address

Login into the unit. (Default: Username: administrator / Password: blank, no password)

Once in the CLI (Command Line Interface), enter the following commands:

1) enable
2) configure
3) debug context sip-gateway transport detail 5
4) debug context sip-gateway error detail 5
5) debug call-control detail 5
6) debug ccfxo
7) debug fxo

Be sure to press enter after each command.

This will allow you to log and capture all traffic through the Patton Device for debugging/troubleshooting purposes. 
(3 vote(s))
Helpful
Not helpful

Comments (0)