How do I run a system debug on a Patton Gateway?

Using an SSH client, SSH or Telnet into the Patton's IP address

Login into the unit. (Default: Username: administrator / Password: blank, no password)

Once in the CLI (Command Line Interface), enter the following commands:

1) enable

2) configure

3) debug context sip-gateway transport detail 5

4) debug context sip-gateway error detail 5

5) debug call-control detail 5

6) debug ccfxo

7) debug fxo

Be sure to press enter after each command.

This will allow you to log and capture all traffic through the Patton Device for debugging/troubleshooting purposes.